Responder 
 
Avaliação do Tópico:
  • 0 Votos - 0 Média
  • 1
  • 2
  • 3
  • 4
  • 5
ath9k carrega mas não encontra redes (resolvido)
05/05/2011, 10:46 (Resposta editada pela última vez em: 05/05/2011 12:27 por caiovitor.)
Resposta: #1
ath9k carrega mas não encontra redes (resolvido)
olá pessoal, estou com dificuldades em usar wifi no meu debian... bom estou usando a versão "test", agora o wheezy, está instalado o madwifi e o firmware atheros; consigo carregar o modulo com "modprobe ath9k" e o networkmanager do gnome passa a reconhece-lo, o led do note de ativado tb acende, mas não encontra nenhuma rede, sendo que estou do lado do roteador e o outro note encontra e usa tranquilamente. e ai vai algumas coisas pra ajudar a analisar:

a placa
Código:
lspci:
Network controller: Atheros Communications Inc. AR928X Wireless Network Adapter (PCI-Express) (rev 01)


resposta ao comando:
Código:
ifup  -a
Ignoring unknown interface wlan0=wlan0.

resposta ao :
Código:
dmesg | grep -e ath -e wlan

[    5.731483] ath9k 0000:02:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[    5.731493] ath9k 0000:02:00.0: setting latency timer to 64
[    6.162076] ath: EEPROM regdomain: 0x69
[    6.162078] ath: EEPROM indicates we should expect a direct regpair map
[    6.162082] ath: Country alpha2 being used: 00
[    6.162084] ath: Regpair used: 0x69
[    6.199013] ieee80211 phy0: Selected rate control algorithm 'ath9k_rate_control'
[    6.199664] Registered led device: ath9k-phy0::radio
[    6.199687] Registered led device: ath9k-phy0::assoc
[    6.199711] Registered led device: ath9k-phy0::tx
[    6.199733] Registered led device: ath9k-phy0::rx
[   15.183511] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   71.370329] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 1351.713035] ath9k 0000:02:00.0: PCI INT A disabled
[ 1351.713093] ath9k: Driver unloaded
[ 1360.700659] ath9k 0000:02:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 1360.700678] ath9k 0000:02:00.0: setting latency timer to 64
[ 1361.129931] ath: EEPROM regdomain: 0x69
[ 1361.129933] ath: EEPROM indicates we should expect a direct regpair map
[ 1361.129937] ath: Country alpha2 being used: 00
[ 1361.129939] ath: Regpair used: 0x69
[ 1361.136403] ieee80211 phy0: Selected rate control algorithm 'ath9k_rate_control'
[ 1361.137101] Registered led device: ath9k-phy0::radio
[ 1361.137128] Registered led device: ath9k-phy0::assoc
[ 1361.137152] Registered led device: ath9k-phy0::tx
[ 1361.137187] Registered led device: ath9k-phy0::rx
[ 1361.182749] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 2006.565004] ath9k 0000:02:00.0: PCI INT A disabled
[ 2006.565068] ath9k: Driver unloaded
[ 2098.833900] ath9k 0000:02:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 2098.833911] ath9k 0000:02:00.0: setting latency timer to 64
[ 2099.264523] ath: EEPROM regdomain: 0x69
[ 2099.264525] ath: EEPROM indicates we should expect a direct regpair map
[ 2099.264529] ath: Country alpha2 being used: 00
[ 2099.264531] ath: Regpair used: 0x69
[ 2099.270867] ieee80211 phy1: Selected rate control algorithm 'ath9k_rate_control'
[ 2099.271567] Registered led device: ath9k-phy1::radio
[ 2099.271594] Registered led device: ath9k-phy1::assoc
[ 2099.271619] Registered led device: ath9k-phy1::tx
[ 2099.271656] Registered led device: ath9k-phy1::rx
[ 2099.315600] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 2106.452973] ath9k 0000:02:00.0: PCI INT A disabled
[ 2106.453028] ath9k: Driver unloaded
[ 2128.216455] ath9k 0000:02:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 2128.216475] ath9k 0000:02:00.0: setting latency timer to 64
[ 2128.645716] ath: EEPROM regdomain: 0x69
[ 2128.645722] ath: EEPROM indicates we should expect a direct regpair map
[ 2128.645731] ath: Country alpha2 being used: 00
[ 2128.645736] ath: Regpair used: 0x69
[ 2128.653252] ieee80211 phy2: Selected rate control algorithm 'ath9k_rate_control'
[ 2128.654867] Registered led device: ath9k-phy2::radio
[ 2128.654953] Registered led device: ath9k-phy2::assoc
[ 2128.655013] Registered led device: ath9k-phy2::tx
[ 2128.655088] Registered led device: ath9k-phy2::rx
[ 2128.698505] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 2628.112843] ath9k 0000:02:00.0: PCI INT A disabled
[ 2628.112905] ath9k: Driver unloaded
[ 2758.559735] usbcore: registered new interface driver ath9k_hif_usb
[ 3003.909975] ath9k 0000:02:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 3003.909987] ath9k 0000:02:00.0: setting latency timer to 64
[ 3004.340798] ath: EEPROM regdomain: 0x69
[ 3004.340800] ath: EEPROM indicates we should expect a direct regpair map
[ 3004.340805] ath: Country alpha2 being used: 00
[ 3004.340807] ath: Regpair used: 0x69
[ 3004.346970] ieee80211 phy3: Selected rate control algorithm 'ath9k_rate_control'
[ 3004.347675] Registered led device: ath9k-phy3::radio
[ 3004.347700] Registered led device: ath9k-phy3::assoc
[ 3004.347728] Registered led device: ath9k-phy3::tx
[ 3004.347775] Registered led device: ath9k-phy3::rx
[ 3004.397258] ADDRCONF(NETDEV_UP): wlan0: link is not ready
Código:
iwlist wlan0 scan
wlan0     No scan results

meu : /etc/modprobe.d/blackist.conf

blacklist evbug

# these drivers are very simple, the HID drivers are usually preferred
blacklist usbmouse
blacklist usbkbd

# replaced by e100
blacklist eepro100

# replaced by tulip
blacklist de4x5

# replaced by tmscsim
blacklist am53c974

# these watchdog drivers break some systems
blacklist iTCO_wdt


blacklist ath
blacklist cfg80211
blacklist mac80211



bom, acabou minhas opções de tentar solucionar isso, continuo tentando mas queria ver se alguem pode me ajudar...

valeu,

abç

[/code]
Encontrar todas as respostas deste usuário
Citar esta mensagem em uma resposta
05/05/2011, 12:26
Resposta: #2
RE: ath9k carrega mas não encontra redes
resolvido.... problema no router... reconfigurei o roteador e agora tenho acesso em todos os computadores,

valeu mesmo assim!

abz
Encontrar todas as respostas deste usuário
Citar esta mensagem em uma resposta
Responder 


Ir ao Fórum:


Usuários visualizando este tópico: 1 Visitantes

Entre em Contato | Fórum Debian | Voltar ao Topo | Voltar ao Conteúdo | Modo Leve (Arquivo) | Feeds RSS